Many necessary delays can slow down other sequential code However, many of those calls tend to be “blocking” (Send command, Wait, Read results) to be easier to use by the programmer at the expense of the end user’s test plan. Those tend to be a very good starting point to quickly communicate with their equipment to change setpoints and readback measurements but they are often Application Programming Interface (API). Innovate with 100,000 analog ICs and embedded processors, along with software, tools and the industrys largest salessupport staff.Equipment manufacturers often make LabVIEW “drivers” available for download on their website. TI, its suppliers and providers of content reserve the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice. Use of the information on this site may require a license from a third party, or a license from TI.Īll postings and use of the content on this site are subject to the Terms of Use of the site third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms of Use of this site. No license, either express or implied, by estoppel or otherwise, is granted by TI. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. I hope the community can provide more insights into the issues you are seeing. You can download the firmware source code from the AFE4403 tools folder at ti.com You can use a serial port sniffer to compare the data from the serial port versus the data you are reading from your Labview VIs and figure out what is possibly going wrong. Im assigning your post to the correct applications engineers. That does not account properly for the fact that the data is 22 bit twos complement. I finally wrote code to sync up using this and to parse the data from that point. Here are my problems, they seem to match others problems but nobody has posted what they did to get it to finally work so I and stuck. Using the GUI and the commands to read the values, the software version of the EVM is 2.2. Labview Parse Serial Data Software Version Of I have read many of the posts here and in the LabVIEW forums, following carefully the recomended solotions.

Labview Parse Serial Data Software Version Of.